Woodworking can be a great hobby for people from all walks of life. Whether you are an expert, or are just getting started, there is always something new for you to learn about the woodworking skill. If you like to learn more about this hobby you should read the article that follows below for some great advice.
Organize your shop’s extension cords to keep your shop safe and tidy. You can make your own cord keeper with nothing more than a scrap piece of wood. Simply cut a piece of wood in the shape of an I and wrap each of your extension cords around the wood.
Familiarize yourself with the tools that you are going to use. This is a very important tip for the beginner, but even more advanced woodworkers can benefit from it too. Lay out the tools and make sure that you know the workings of each one. If you’ve got a brand new tool to you, spend the time that you need with it.
Always put your safety first when it comes to using tools, stains and paints. The more variety you use, the more specifics there are about applications, tool use, times for drying, and more. Put your safety first by reading the instructions, wearing any necessary protective gear, and working in areas with good ventilation whenever using oil-based products or anything that produces air pollutants.
When you install your hacksaw blade, make sure the teeth face forward. They are designed to cut when pushed using a forward stroke instead of a pulled stroke. Some of these blades have arrows pointing toward the handles that show the correct way to install them. Install it making sure it is tight and cannot bend. When you do lots of cutting, your blade heats up and expands, so make sure you tighten it before it begins bending.
When working with wood, it is important that you have a lot of patience when it comes to the finishing process. This is just as important as the actual woodworking. Things like gluing edges and sanding the wood down take time, and you will only mess things up if you try to rush through this process.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
As you read at the beginning of this article, there is so much that you can learn about woodworking that you will never know everything. However, even though that is a fact, there is no reason to not try. Now that you read this article you know a little more, and continuing to learn will only lead you to being a better woodworker.…